BL Bench Lathes

BL BENCH LATHE

BL BENCH LATHE WITH TAPERED SPINDAL'S; $199.00

Powerful variable sped bench lathe in a compact size suitable for use at the work bench. Its permanent magnetic motor is extremely quite and smooth running with all the power and speed required for a variety of polishing and buffing jobs. Cast iron base has suction cup feet for a secure hold on the work surface. Lathe comes with the TM-5 (left hand) and TM-6 (right hand) Tapered Spindals for holding buffs and brushes up to 4" (100mm) in diameter. Other lathe accessories are available separately and shown below. Available at same price in 230 Volt CE marked. Specify BL-2

Available for use with standard BL Lathes with 3/16" Dia. motor shafts and discontinued BL's with 1/4" Dia. motor shafts. Accessories for the 1/4" shaft can also be used with discontinued B & G High Speed Grinders. BE CAREFUL TO SPECIFY THE CORRECT ACCESSORY WHEN ORDERING.

ACCESSORY

St'd Accessories

For use on 5/16" BL

Lathe motor shafts

1/4" Accessories

For use on 1/4" BL

Lathe and Bench

Grinder motor shafts

ACCESSORY

St'd Accessory

For use on 5/16" BL

Lathe motor shafts

1/4" Accessory

For use on 1/4" BL

Lathe and Bench

Grinder motor shafts

1 Tapered Spindale $10.00 ea.

For left and right hand mounting of buffs and wheels up to 4" Dia. Also for3M Scotch Radial Bristle Disc's with pre-mounted Spindle Adaptors.

TM-5 (left hand)

TM-6 (right hand)

TM-3 (left hand)

TM-4 (right hand)

4 Jacob Chuck arbor $45.00 ea.

Arbor adjusts to hold accessories with shank from 0-5/32". Comes with chuck key. se only on right hand side, Not available for lathes with 1/4" Dia. motor shafts.

JCA-2 (right hand)

JCA-1 (right hand)

2 Plastic Spindle Adaptor $3.00 ea

.For mounting 2"and 3" 3M Scotch Bright

Radial Bristle Disks with 3/8" arbor holes, left and right hand sides.

4562 (left hand)

4561 (right Hand

4562 (left hand)

5 Collet Holder $20.00 ea.

Collet holder on arbor comes with 3/32" collet for mounting 3/32" shank

For mounting 3/32" Shank accessories for use on right hand side only. Other collet sizes available.

CHA-1 (left hand)

CHA-1 (right hand)

3 Collet Holder $20.00 ea

Collet holder on arbor comes with 1/4" collet for mounting larger 1/4"shank mandrel's, sanding drums etc. For use on right hand side only. Other collet sizes available.

CHA-5 (right hand)

CHA-4 (right hand)

6 WHEEL MANDREL $14.00 ea.

Hold rubber bonded abrasive wheels, sanding drums and other accessories with 1/4" mounting holes.

WM-5 (left hand)

WM-3(left hand)

PRICES SUBJECT TO CHANGE WITHOUT NOTICE

MINIMUM ORDER $30.00